Bar X

[dazzer]

Here goes I been having a problem with the display on a Bar x 10
electrocoin so I changed the MPU and on turning on the machine the reels just keep going around stop for about a few secs and then repeat, dont know where to look now. but old board back in and it do the same was allright before.

Have I fryed the program chip.

On the board bown the right hand side:

there are plugs connected to

HD1 HD2 HD9 anyone know what are connected to theses or is there a list anywhere saying what HD1 HD2 HD3 HD4 HD5 HD6 HD7 HD8 HD9 HD10 HD11 HD12 what are pluged on these

Thanks for any help

[lee]

the program will be ok,when you have taken the board out you had to remove the reels and it is likely you have pushed a pin out of reel 1,as the other reels won,t set up until number 1 does.The machine will still set up without the HD plugs out as they are only lamps except for HD 10 which is a hopper divert connector