wet n wild mazooma new psu fitted not working help please

wosupmup · Post by **wosupmup** » Sun May 02, 2010 2:49 pm

i have a wet n wild mazooma fruit machine i had a power supply problem i was told so got a new power supply fitted it and it worked fine for 2 weeks switched on this morning it lit up then nothing i have 1 red led lit on board and 4 green led lit up and the light on the coin mec is lit but nothing else ive checked all the connections and the eproms is there anything else i can do or is it time to call it a day any help would be appreciated thanks

dazzer · Post by **dazzer** » Mon May 03, 2010 5:57 pm

Cheak that the program card is fitted ok on the mpu. i guess the belly lamp is working at the front of the machine, best to turn power off when removing and reseating program card as well

wosupmup · Post by **wosupmup** » Tue May 04, 2010 8:25 am

i switched it on yesterday and it worked for 5 mins but no lights worked ive checked nearly every wire plug and the cards dont know if something has blown do you know what part of board or what card workes the lights is there like a safe mode on bandits thanks mark

wosupmup · Post by **wosupmup** » Tue May 04, 2010 8:26 am

sorry can you tell me what a belly lamp is thanks again

wosupmup · Post by **wosupmup** » Tue May 04, 2010 9:23 pm

bandit now working just no lights help please

dazzer · Post by **dazzer** » Wed May 05, 2010 2:20 pm

so machine is working fine now, but no lamps working at all, the belly lamp is the light at the front of the machine. what mpu is fitted in this machine? the name with be on the mpu or take a photo of it.

Reel King · Post by **Reel King** » Wed May 05, 2010 4:44 pm

dazzer, think it's a feature so won't have, belly glass.

so you have the machine working but no lights?

do you have +12v coming from; (i'm guessing it's a stadium,) PSU?

if so..

make sure you have +12v to mpu by testing the loom

are all leds on on MPU?

wosupmup · Post by **wosupmup** » Mon May 10, 2010 3:09 pm

i have all the green lights on on the board including the 12v green light the red led is not on unless i reset it it is a stadium power source the only other thing is the switch for the top door is not working either dont know if there is any power going to the door or the lights on the start hold etc panel have taken all the boards out to see if the solder has given up but all seems ok i did a lamp test through the settings but just comes up lamp test but nothing happens just wondering is there a chip or something that controls the lights thanks