we have a maygay machine works perfect but tried to transfer note acceptor from other machine we also had a £25.00 jackpot italian job with note acceptor we have transfered note acceptor to coronation street and installed wire from square pcb with black box over it and turned machine on lcd display does not say note acceptor found and note load into machine then they are rejected note acceptor has four leds on top only led 2,3 are lit and slow flashing
can anyone help note acceptor are square and grey believe n7
maygay coronation street £250 jackpot note acceptor problem
-
blackpoolpaul
- Junior Member
- Posts: 1
- Joined: Wed Apr 14, 2010 7:07 pm
- Location: blackpool
-
clarkey1984
- Senior Member
- Posts: 633
- Joined: Wed Aug 26, 2009 8:49 pm
I may be way off the mark with this as you mentioned that the notey was in another machine before, but i know that as a general rule note acceptors need calibrating, which means you need a LOT and i mean LOT of notes in order to calibrate it with first.
deano8177 wrote:When I rang him I asked if I could play any of the gaming machines and he said no cos they keep getting fiddled. Then I said I'd be down soon to watch the football, and that I was going to shit in his urinal.
thecannonball89 wrote:If you go out on a friday night to play a deadmans and end up going out up town having 5bags of heavly cut drugs end up in the brothel, and wake up feeling like shit on monday morning sitting out a p3 dial trying to make bk ur losses of a 5am roulette sesion, your probly a player
If it worked in another Maygay machine, then the note acceptor is almost certainly ok.
I'm assuming that both machines were connected to the note acceptor using the same PCB beneath the black box (the hopper driver board) with the same loom ?
If so, it's highly likely that everything is actually ok, and that you've just forgotten to set the Dill settings accordingly. I would suggest you copy the settings from your 1st machine to your new machine as a starting point, although someone else will probably tell you exactly what the settings should be.
I'm assuming that both machines were connected to the note acceptor using the same PCB beneath the black box (the hopper driver board) with the same loom ?
If so, it's highly likely that everything is actually ok, and that you've just forgotten to set the Dill settings accordingly. I would suggest you copy the settings from your 1st machine to your new machine as a starting point, although someone else will probably tell you exactly what the settings should be.