Page 1 of 1

Horizon 2 MPU6 SEC Meter Wiring

Posted: Thu Dec 08, 2016 7:34 pm
by Steady88
Hello

At my Whits end with this problem.

Had continous issues with my sec meter.

Replaced 3 times with new units and works fine before I get the LCD meter NOT FOUND error.

Traced wires though the whole machine and can't find any breaks.

Cable seems to merge with logo lamps (top of the unit) but it seems to visit each individual lamp.

Anyone got advice on next thing to check?
Or
Where the wiring ultimately ends up?

Meter display is working BTW just undetected??

Thanks in advance.

Posted: Thu Dec 08, 2016 8:07 pm
by buzzer
the sec wires go straight to the mpu, they are all coloured black and should not pass through anything in the lamp matrix.

my guess?

the wire/s have been trapp/ed and snapp/ed by the door frame and reconnected incorrectly.

the problem lies with whatever wire is connected to logo lamp. take the wire off the lamp altogether

Posted: Fri Dec 09, 2016 8:28 am
by Steady88
Thanks for the info. I have managed to trace black wires and white wire back to mpu. It's the single red wire that runs into the lamps. I assume this is power. Shall I disconnect sec meter and power through somewhere else?

Sorry to be vague with this!

Posted: Fri Dec 09, 2016 6:30 pm
by buzzer
might be easier to post an image.. :)

the meter wires are completetly spererate from the lamp matrix....