Fruit Machine Chat

Anyone here know much about note changers?

Im trying to manually program my nv4 to take the new £20 note.

Everytime I put it into teach mode, and then select the channel I want to use, it wont take notes like it should..

Any ideas?

Cheers.

The NV4 Validator may be taught new currency or notes in three ways:

1. Use the NV4 /5 Currency Manager Software, which is supplied with a range of currencies. To use this system you will require a PC running Windows, Pentium,75MHz or faster with a serial port, and a 12volt dc power supply to power the validator.
2. NV4 / 5 Master/Slave copying - a currency set can be transmitted from one NV4 onto another or an NV5. Note it is not possible to clone an NV4 from an NV5.
3. Manual teaching using a selection of bank notes (NV4 Only). This method is not preferred and should only be used if the other alternatives are not available to you. Please be aware that some currencies have currency specific parameters associated with them. These may not be appropriate if the NV4 is re-taught manually. If an electronic method is used any special parameters will automatically be updated to suite the currency.
OR
It could be your validator has been set with a three digit code lock to prevent unauthorised access.
If it is locked when you set the switch to teach the second LED will light up.
hope this helps.

Thanks for your reply.

Ive done a bit of searching, and have found that the teach function was disabled in later firmwares. I know it doesnt have a pin, so it must have a new firmware installed..

I dont have the software or cable to connect to a PC, so it looks like I will be paying a visit to ebay!