new 10 pencew piece

nipa1970 · Post by **nipa1970** » Tue Nov 25, 2014 8:58 pm

hi i have just acquired spiker the biker machine and was wondering is it possible to reprogram the slot for the new 10 pence piece thanks in advance

duomat · Post by **duomat** » Tue Nov 25, 2014 11:34 pm

I think that is quite an old machine,by old i guess about 8 years.I would say not,i may be wrong but these new 10ps are not accepted by vending machines of only 12 months old

Spyder · Post by **Spyder** » Wed Nov 26, 2014 11:30 am

Spiker the biker was made in 2000!!

buzzer · Post by **buzzer** » Wed Nov 26, 2014 3:11 pm

its simple a matter of updating with newer correctly configured coinmech.
a new mei cashflow mech or sr5i or sr5e could be configured to work properly in it..

nipa1970 · Post by **nipa1970** » Thu Nov 27, 2014 7:05 pm

thanks for your reply chaps so where could i get one or point me in the right direction to purchase thanks

dog section · Post by **dog section** » Thu Nov 27, 2014 11:07 pm

on ebay theres a few new mechs that state theyre updated, or you can send yours away to be upgraded and returned. couple firms were advertising this service on there

nipa1970 · Post by **nipa1970** » Sun Nov 30, 2014 9:51 am

ok im total noobie what coin mech would be in mine barcrest spiker the biker cheers

buzzer · Post by **buzzer** » Sun Nov 30, 2014 1:40 pm

could be a couple of diffrent mechs, post a picture of it...

MrOsborne · Post by **MrOsborne** » Tue Jan 27, 2015 5:40 pm

I have the same issue, but most coin mechs don't like the new shiny 10p's