Page 1 of 1
Bar X driver Board
Posted: Mon May 16, 2011 7:54 pm
by dazzer
Hi Is there any way you can by pass the hopper driver board on a casino Bar x
I have attached a pic of the driver Board
Thanks
Posted: Mon May 16, 2011 8:09 pm
by lee
this board changes the voltage down to 9.5 v ac,you can't really bypass it,Why not just change the transformer,we do when it packs up and stops driving the hopper
Posted: Mon May 16, 2011 8:22 pm
by dazzer
do you just replaced the Board if so how? or do you have to change the whole unit
Posted: Mon May 16, 2011 8:30 pm
by lee
you can change the full unit,Electrocoin sell them,or I buy the transformers from cpc and just unsolder the burnt out one ,we normally go through a couple of them in a month
Posted: Mon May 16, 2011 8:47 pm
by dazzer
I havent Metered the unit as I not to sure how?
Posted: Mon May 16, 2011 8:56 pm
by lee
You can see just by looking at the transformer that it is burnt out,if you wanted to, just put your meter on ac then across the secondary windings
and you would see 0v
Posted: Mon May 16, 2011 9:46 pm
by dazzer
so by looking at my pic you would say its burnt out?
thank you for your help
Posted: Mon May 16, 2011 10:35 pm
by lee
Definitely
Posted: Tue May 17, 2011 5:38 pm
by dazzer
This machine is being a big pain at the moment, started of with resetting (F)
The psu (+44), board, program chip have all been replaced, to try and find what causing this fault