Bar X driver Board

dazzer · Post by **dazzer** » Mon May 16, 2011 7:54 pm

Hi Is there any way you can by pass the hopper driver board on a casino Bar x

I have attached a pic of the driver Board

Thanks

lee · Post by **lee** » Mon May 16, 2011 8:09 pm

this board changes the voltage down to 9.5 v ac,you can't really bypass it,Why not just change the transformer,we do when it packs up and stops driving the hopper

dazzer · Post by **dazzer** » Mon May 16, 2011 8:22 pm

do you just replaced the Board if so how? or do you have to change the whole unit

lee · Post by **lee** » Mon May 16, 2011 8:30 pm

you can change the full unit,Electrocoin sell them,or I buy the transformers from cpc and just unsolder the burnt out one ,we normally go through a couple of them in a month

dazzer · Post by **dazzer** » Mon May 16, 2011 8:47 pm

I havent Metered the unit as I not to sure how?

lee · Post by **lee** » Mon May 16, 2011 8:56 pm

You can see just by looking at the transformer that it is burnt out,if you wanted to, just put your meter on ac then across the secondary windings
and you would see 0v

dazzer · Post by **dazzer** » Mon May 16, 2011 9:46 pm

so by looking at my pic you would say its burnt out?

thank you for your help

lee · Post by **lee** » Mon May 16, 2011 10:35 pm

Definitely

dazzer · Post by **dazzer** » Tue May 17, 2011 5:38 pm

This machine is being a big pain at the moment, started of with resetting (F)

The psu (+44), board, program chip have all been replaced, to try and find what causing this fault