Hi,
I have pharoahs gold- bell fruit machine with the scorpion 4 board in it.
I have just bought a note acceptor for it from ebay which i was told will work with bell fruit machines its an nv8 acceptor.
However the cable that came with it doesnt seem to match up to the circuit board....can you get different cables or is it just these two arent compatible? if you can plug it in.....where does it go...direct to the motherboard?
thanks
note acceptor
-
- Junior Member
- Posts: 9
- Joined: Wed May 09, 2007 8:46 pm
Im not too sure...all i know is the board doesnt have a socket spare or big enough for the plug on the acceptor.
The instruction manual mentions a note acceptor...and I know the machine has the blanking plate for one...so it must be possible???
Any ideas how i would sort or find out the software level?
The instruction manual mentions a note acceptor...and I know the machine has the blanking plate for one...so it must be possible???
Any ideas how i would sort or find out the software level?
-
- Junior Member
- Posts: 9
- Joined: Wed May 09, 2007 8:46 pm
I'm guessing, its a none note reader software machine, they would then send you a note reader and loom and software all for a tidy amount.
I think it will be a parallel note reader machine as the board is old, I'm note sure how you can tell sorry. Id be surprised if it has the right software and is switchable via a dill switch, but you never know
I think it will be a parallel note reader machine as the board is old, I'm note sure how you can tell sorry. Id be surprised if it has the right software and is switchable via a dill switch, but you never know