Barcrest supernova 2xred 1xgreen any ideas what should be done ?

Adam0113 · Post by **Adam0113** » Wed Dec 24, 2014 4:49 pm

Not working just the lights to show faults

buzzer · Post by **buzzer** » Wed Dec 24, 2014 6:41 pm

it means ram test fail.

replace the mpu5

Adam0113 · Post by **Adam0113** » Wed Dec 24, 2014 7:48 pm

Thanks buzzer Iv ordered one from ebay should be here in a couple of days Iv removed the other so when it comes is there any certain way I should put it in or just same as how I removed amd do I put the same program module in ?

buzzer · Post by **buzzer** » Wed Dec 24, 2014 9:34 pm

just the same and make sure the dil switches are the same,

as long as you dont have a note acceptor , there should be no problem..

Adam0113 · Post by **Adam0113** » Wed Dec 24, 2014 10:29 pm

I don't have not accepter

are the dill switches on program module 1-9 not sure if they are all correct not sure where they are

Adam0113 · Post by **Adam0113** » Wed Dec 24, 2014 10:30 pm

Is it the first that says on and off ?

Adam0113 · Post by **Adam0113** » Wed Dec 24, 2014 10:36 pm

Is there anyway to see what position they go ?

buzzer · Post by **buzzer** » Thu Dec 25, 2014 3:17 am

well you will be keeping the program module so forget about them..

there are also 8 dils switches on the mpu5, just copy them to the new one..

Adam0113 · Post by **Adam0113** » Thu Dec 25, 2014 8:25 am

Yes I found them last night so I match the ones from the mpu5 then set the same ones on the program module ? They are all set on the numbers 1-8

buzzer · Post by **buzzer** » Thu Dec 25, 2014 12:23 pm

no, the program module will be staying with yyou, no need to alter anything on it, just plug it in to the new mpu5..

on the new mpu5 make sure the switches on the new board match the old board (and they probably will, they don't get used for much) simple as that..

Adam0113 · Post by **Adam0113** » Thu Dec 25, 2014 5:02 pm

IM not sure if the previous owner could of messed around with the switches they are currently on 1 2 3 4 5 6 7 8 on the mpu5 and same with the programme module not sure if it's correct or not because the previous owner knew nothing about the machine and didn't bother looking up what was wrong with it so I'm hoping they didn't mess with the switches trying to get it to work if so how would I find out where the switches should be for it all to run correctly I dnt want to switch it on for something to go more wrong with it when I get the new mpu5 merry Xmas btw

and thanks you been great